After that, you must unlock the exhausted toner cartridge by pulling its plastic tab towards you, and then use the handle to take the exhausted consumable part out of the copier. Initially, you must open the left cover of your Canon Copier ImageClass MF6530, and then locate the blue plastic tab of the exhausted toner cartridge. It is always a better, if you keep a spare toner cartridge for your ImageClass MF6530 in stock, but please remember to store all consumable copier's components/parts in accordance with the manufacturer's instructions and recommendations.
Canon imageclass mf6530 not printing install#
However, you will have to install a new toner cartridge, if the message is still appearing after a correct re-installation of the toner cartridge. ''TONER IS NOT SET INSERT TONER'' – This message is normally indicating an incorrect toner cartridge installation. You should install a new toner cartridge soon after the initial appearance of this advance notification, in order to be avoided interruptions of your work caused by a non-operational copier's mode.
''TONER LOW PREPARE NEW TONER'' – This message indicates that the installed toner cartridge is nearly empty, and it will be completely exhausted very soon. You should replace the installed toner cartridge, if any of the listed and described below messages appears on the LCD of your laser copier. Once the built-in system detects a toner cartridge related abnormality, it will display an appropriate warning or error message on the control LCD specifying the detected issue. The precise built-in system of your Canon Copier ImageClass MF6530 is constantly monitoring the status of all installed consumable components. If you see this error you should contact a technician. This message indicates that the machine may have some problems. To resolve this issue close the cover shown on the lower line of the LCD display. This message tells you that the cover is open. Simply remove the jammed document.Īnother common message that you will see is. Users will see on the screen when a document jam has occurred in the ADF. The message will disappear when transmission restarts. This message will appear due to the fact that the recipient is sending something and the job must wait. Is another message you may see on your LCD screen. This message indicates that the machine is not ready to begin scanning.
One the LCD screen you may see a message that says. Carefully put the paper cassette back into the machine until it clicks. Now pull out the paper cassette and push the corners of the stack under the tabs. Then check the optional paper cassette and open the left side of the optional paper cassette and remove any jammed paper and close the cover. At this point lift the transcription frame and remove the jammed paper. Then tilt the 2-sided transport guide toward the machine and remove any paper that is jammed.
Next carefully remove the jammed paper from the machine. The first step is to open the left cover. If the message PAPER JAM comes up on your LCD display, first deal with the paper jammed inside the machine, then deal with the paper cassette.
0 kommentar(er)
